1

I am new to Linux so please bare with me.
I preformed a fresh install of Kali Linux on my laptop,so now the only operating system available is Kali Linux.
Here's my problem: My laptop cannot connect to the Internet through the already built-in wireless card.
My laptop wireless card is: Intel Corporation Centrino Advanced-N 6200 2x2 AGN and although the system says that it using the kernal drivers for iwlwifi there is still no wireless Internet connection.
I tried changing the interfaces file under /etc/network/interfaces and added:
# The primary network interfaces
auto wlan0
allow-hotplug wlan0
iface wlan0 inet dhcp
Still no luck.
Here's the ifconfig details:

eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 192.168.1.77 netmask 255.255.255.0 broadcast 192.168.1.255 inet6 fe80::223:18ff:febe:ab8e prefixlen 64 scopeid 0x20<link> ether 00:23:18:be:ab:8e txqueuelen 1000 (Ethernet) RX packets 27689 bytes 27448393 (26.1 MiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 15299 bytes 1495734 (1.4 MiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 device interrupt 20 memory 0xd4600000-d4620000 lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536 inet 127.0.0.1 netmask 255.0.0.0 inet6 ::1 prefixlen 128 scopeid 0x10<host> loop txqueuelen 1 (Local Loopback) RX packets 2460 bytes 187820 (183.4 KiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 2460 bytes 187820 (183.4 KiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 wlan0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500 ether 00:27:10:94:a8:3c txqueuelen 1000 (Ethernet) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 


Here's the iwconfig details:

lo no wireless extensions. wlan0 IEEE 802.11abgn ESSID:"ATT653" Mode:Managed Access Point: Not-Associated Tx-Power=15 dBm Retry short limit:7 RTS thr:off Fragment thr:off Encryption key:off Power Management:off eth0 no wireless extensions. 

NOTE: For the ESSID, I manually added "ATT653" using

ifconfig wlan0 up iwconfig wlan0 essid "ATT653" dhclient wlan0 

This didn't work because my network is WPA2 encrypted.
Here's the wireless card information:

root@kali:~# lspci 02:00.0 Network controller: Intel Corporation Centrino Advanced-N 6200 (rev 35) 


and

root@kali:~# lspci -vq 02:00.0 Network controller: Intel Corporation Centrino Advanced-N 6200 (rev 35) Subsystem: Intel Corporation Centrino Advanced-N 6200 2x2 AGN Flags: bus master, fast devsel, latency 0, IRQ 29 Memory at d4400000 (64-bit, non-prefetchable) [size=8K] Capabilities: [c8] Power Management version 3 Capabilities: [d0] MSI: Enable+ Count=1/1 Maskable- 64bit+ Capabilities: [e0] Express Endpoint, MSI 00 Capabilities: [100] Advanced Error Reporting Capabilities: [140] Device Serial Number 00-27-10-ff-ff-94-a8-3c Kernel driver in use: iwlwifi Kernel modules: iwlwifi 

Please help me get this issue resolved.

1 Answer 1

0

Edit your sources.list :

nano /etc/apt/sources.list 

add the following line:

deb http://http.kali.org/kali kali-rolling main contrib non-free 

then install iwlwifi driver:

apt-get update && apt-get install firmware-iwlwifi rmmod iwlwifi modprobe iwlwifi 

edit

Use the retired repo:

deb http://old.kali.org/kali sana main non-free contrib 
1
  • 1
    nope it did not work. This is what gets displayed on Terminal pastebin.com/UuHsWY8p Commented Sep 10, 2016 at 20:39

You must log in to answer this question.

Start asking to get answers

Find the answer to your question by asking.

Ask question

Explore related questions

See similar questions with these tags.