2

I am using a Vilros Raspberry Pi 4 with Raspbian. The RPi works, but every time I boot the system, nothing shows up on my monitor (resolution 2048x1080), just a black screen. I can blindly enter my credentials, then run startx, then the GUI shows up no problem on my monitor and everything is good.

This happens when I start the RPi with everything (keyboard, mouse, monitor) already plugged in, monitor in HDMI 0. When I boot the RPi without the monitor plugged in, then plug it in once its ready to go, I can see the boot screen/terminal, but the resolution is bad because the system used some other poorer resolution than 2K.

List of all the things I've tried (which failed): Going into /boot/config.txt and setting (at different times):

  • disable_overscan=1

  • framebuffer_width=2048

  • framebuffer_height=1080

  • config_hdmi_boost=4.

  • also, hdmi_force_hotplug=1 by default from NOOBS, so that is already set.

I also tried hitting enter/typing in gibberish to the black screen, but that gave me nothing. If anyone could help me out with this problem, it would be much appreciated.

Improve this question
1
  • Thats a weird resolution. I would not use Noobs, flash 'Raspbian Buster with Desktop' direct to sd card with Etcher. More likely to detect your screen properly. Commented Apr 21, 2020 at 21:09

1 Answer 1

Reset to default
1

I was able to resolve my problem by running

sudo raspi-config

then using advanced options -> resolution, and setting my resolution to DMT 1920x1080p.

In /boot/config.txt, this sets:

hdmi_group=2

hdmi_mode=82

This was for a Viotek FI24D monitor which has a resolution of 2560x1440p.

Improve this answer
1
  • Please accept your own answer with a click on the tick on its left side. Only this will finish the question and it will not pop up again year for year. Commented Apr 24, 2020 at 18:14

Start asking to get answers

Find the answer to your question by asking.

Ask question

Explore related questions

See similar questions with these tags.