Skip to main content

Questions tagged [supercapacitor]

Very high energy-density capacitors, typically measured in farads.

-2 votes
2 answers
116 views

I’m looking for schematic references or design examples to understand how supercapacitors are typically integrated into electronic circuits. I want to use Supercapacitors as a power backup for ...
akash Pulikkal's user avatar
2 votes
1 answer
157 views

I want to make a device which works on DC, it consumes 2 W. It continues working mode. With the help of a solar cell and a lithium ion battery we can operate it. If I want to replace the battery with ...
Manu Mohan M S's user avatar
0 votes
0 answers
66 views

I’m working on a small project and would love a sanity check on my schematic (will attach below) — especially from anyone experienced with ESP32 power design and supercapacitor setups. Goal: I want an ...
Frusciante89's user avatar
1 vote
2 answers
153 views

At the moment I have a solar charger circuit (shunt regulator for overcharge protection) that charges battery (LIC) from PV and it works nice. But there is a problem with night discharge. I measured ...
fel88's user avatar
  • 85
2 votes
4 answers
272 views

Solar Panel 6V (https://aliexpress.ru/item/1005006020071511.html?sku_id=12000042919843716) LIC capacitors 4V 200F (https://item.szlcsc.com/3567431.html?lcsc_vid=...
fel88's user avatar
  • 85
3 votes
1 answer
94 views

I have got 2 supercapacitors and both of them are 2.7 V 3000 F. I need to create two test scenarios for these two capacitors. Voltage Regulation Test: Scenario: Absorption of voltage fluctuations in ...
Kağan's user avatar
  • 31
2 votes
0 answers
102 views

I'm having trouble understanding how high ESR affects the charging current of supercapacitors. I also need some equations to help clarify this. I’m using a supercapacitor array: 7 capacitors in ...
chami's user avatar
  • 649
1 vote
5 answers
179 views

I want to drive a mini solenoid that pulls a springloaded lever. I've tested the solenoid in this setup with a benchtop power supply and it works correctly when using 9V 1,5A. This power burst only ...
Leo's user avatar
  • 49
1 vote
1 answer
88 views

I have a Raspberry Pi Pico powered by solar panels and super capacitor. Experiment 1: Power Pico using solar. VSYS rises to 5.09V after some minutes and onboard green LED comes on as the voltage rises ...
Shep's user avatar
  • 199
1 vote
3 answers
320 views

I have an image of a blinking LED circuit powered by sunlight, using an array of BPW34 PIN diodes to charge what I think is a supercapacitor. It appears to be an energy harvesting project. I’d like ...
Farhad's user avatar
  • 109
3 votes
2 answers
992 views

I am using a motor that requires 20 Amps at 75 Volts. The motor may consume up to 45 Amps for short periods of time, also at 75 Volts. Assuming I already have a battery pack that can supply 20 Amps at ...
Yigit_Yildirim's user avatar
0 votes
0 answers
106 views

I am using the LT8390 as a supercapacitor charger for a 5S10P configuration of 20F capacitors. Based on the datasheet, this chip supports supercapacitor charging. I understand that the capacitors need ...
chami's user avatar
  • 649
0 votes
2 answers
170 views

I have a design that uses a Elna super capacitor to backup a real time clock (RTC). The supercap is being discontinued and I can't find a suitable replacement. It seems this entire market is shutting ...
Lehrian's user avatar
  • 109
2 votes
1 answer
139 views

I'm trying to model an MCU powered on batteries. The MCU will be sending data over BLE, so it will pull a large amount of current; more than the maximum discharge current of the battery. To solve this ...
Martel's user avatar
  • 1,463
1 vote
1 answer
321 views

I’m working on a balancer circuit that’s part of a supercapacitor charging system, but I’m having trouble understanding how it works. Specifically, I’m confused by how the values of V1-VA and VE-SCAP ...
chami's user avatar
  • 649

15 30 50 per page
1
2 3 4 5
25