I have the following config. set up for an MPLS network on my CISCO 878:
Current configuration : 941 bytes ! version 12.4 no service pad service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname MyHost ! boot-start-marker boot-end-marker ! ! no aaa new-model ! resource policy ! ip subnet-zero ip cef ! ! ! ! ! ! ! controller DSL 0 mode atm line-term cpe line-mode 2-wire line-zero dsl-mode shdsl symmetric annex B line-rate auto ! ! ! ! interface BRI0 no ip address encapsulation hdlc shutdown ! interface ATM0 ip address 10.120.240.152 255.255.255.252 no atm ilmi-keepalive pvc 0/95 cbr 2048 ! ! interface FastEthernet0 ! interface FastEthernet1 ! interface FastEthernet2 ! interface FastEthernet3 ! interface Vlan1 ip address 10.22.33.1 255.255.255.0 ! ip classless ip route 0.0.0.0 0.0.0.0 10.120.240.151 ! no ip http server no ip http secure-server ! ! control-plane ! ! line con 0 no modem enable line aux 0 line vty 0 4 login ! scheduler max-task-time 5000 end
Now, the only problem that I had setting those parameters was PVC. I'm supposed to set:
pvc 42/95 But it doesn't accept! Please have a look at this configuration to see where I have gone wrong. When I use the help, it says VPI can't be more than 35. I used pvc 0/95, but it doesn't work when I install the router.
