0
$\begingroup$

As you can see on the image below, I got a lot of vertices after converting the splines to a mesh. The splines a drawn manualy from an old map.

enter image description here

I already started with the filling process. Selecting two edges and fill them with Fwas not a solution, since it causes weird looking artifacts.So my second attempt is to select "nearest" vertices manualy and fill a edge between. This seems a bit tedious and a lot of work.

Does anybody have a good approach to this?

I have a silly Idea in mind: Using a clothing simulation to fall down on my splines and use the fianl result as my shape. Does this sounds like a good Idea?

Improve this question
$\endgroup$

1 Answer 1

Reset to default
1
$\begingroup$

You can select 2 vertices and create an edge as shown on your screenshot.
Then active edge selection mode (2), and spam F which creates faces until the end of the spline is reached. Select the whole spline by pressing L (Select Linked), then remove all faces (X, Only Faces)

Improve this answer
$\endgroup$
2
  • $\begingroup$ Thats a very good hint. Is there also a fast way to create an equal number of vertices on the "curves"? and spread them even? $\endgroup$ Commented Apr 25, 2021 at 16:10
  • 1
    $\begingroup$ I used limited desolve which worked great. The manual workload is reduced drasticly and the result is looking great. $\endgroup$ Commented Apr 25, 2021 at 16:28

You must log in to answer this question.

Start asking to get answers

Find the answer to your question by asking.

Ask question

Explore related questions

See similar questions with these tags.